Crane Brakes

Our mill duty Thruster Brakes are suitable for 440 Volts, 3 Phase A.C. supply for a wide range of drum sizes, from 100mm to 600 mm dia. Higher sizes can also be supplied against specific requirements. The brake is applied by the tension of the compressed springs mounted vertically between the thruster and brake lever. The thruster rods are connected with the brake by means of an angle lever As the piston travels upwards the angle lever tums, pushes the brake rod and compresses the brake spring Simultaneously, the brake lever on the other side of the wheel (Brake Drum) is retracted.

Electro-Hydraulic Thruster A compact 60watt, 2800 rpm. 415v/50Hz/3-ph, non-ventilated motor is directly mounted on the top of a moving aluminum piston. A cast iron tank containing the brake fluid actcs as the cylinder, the piston separates the cylinder into high pressure and low pressure chambers. The bi directional impeller is mounted directly on the motor shaft. The upper clevis in integral with the top and shield of the motor and the lower clevis is on the bottom of the tank cover.

CMK Manufacturing a wide range of brake linings, which is of excellent quality. These are made of soft but tough heat resistant material with a high coefficient of dynamic friction we offer rubber brake linings, asbestos brake linings. automotive brake linings, which are made using a unique blend of ingredients such as asbestos, friction dust, resins etc. These products are used in industrial brake application.

Very compact and modern in design, Foundation is not necessary as they are directly mounted on non-driving end shaft of the motor. It consist of liner prices (Brake Disc) with square hole at the center One corresponding piece of square hub is supplied with the brake. This hub is keyed to the motor shaft and the finer plate is free on this hut Normally Liner plate is gripped between two discs with the help of spring pressure they work on 230 / 415 VAC When the current is supplied to the brake, one disc is attracted by electromagnet against spring pressure and the liner plate os released. Thus the brake is ‘off’. Once the brake is set it dose not required adjustment or maintenance When the liner plates wears with the use then only air gap is to be maintained periodically An arrangement to release the brake manually could be provided on request

AC Solenoid Brake that are suitable for AC supply up to 440 volts, and are available for a wide range of drum sizes from 100mm to 380mm Dia. We stand in the midst of prominent electromagnetic brakes suppliers based in India